Max Diameter 20mm Rebar Bending Mahine

1. The servo controller drives the servo motor to start after receiving the signal.

2. The torsion disc begins to rotate and drive the torsion claw on the disc to make a circular motion, and the torsion claw bends the steel bar to a certain Angle.

3. The Angle sensor measures the bending Angle of the steel bar, and the measurement result is sent to the MCU of the servo controller, the measurement result is compared with the design and processing Angle to obtain the business value, according to the difference of the servo controller drives the motor to rotate the disk again. In the process of steel bar bending, the control system continues to carry out the above steps until the machining Angle and the design Angle are within a certain error range.